QB Fuselage Rework – Part 2

Sometimes you have to go backward to go forward. Drilling out rivets is one of those things you have to do sometimes when building and airplane. Fortunately, I’ve had to do very little reverse-assembly. But, there are a couple of parts I needed to add and I’ve opted for an upgrade to the cowling fasteners that calls for replacement of narrow, factory-mounted parts, with wider aftermarket replacements. Drill baby drill!

There’s a reinforcement plate, near where the ballistic parachute rocket canister mounts. The plate rivets to the RIB that forms the back wall of the parachute compartment. Several rivets had to be drilled out and removed so that the plate could be positioned and riveted. Done.

There was also a missing attachment angle for the top right edge of the parachute compartment. It should have been installed at the factory. It’s going on now, but a few rivets had to be removed before the angle was riveted using those same holes.

To go along with the other rework, I’ve opted for an upgrade to the factory-supplied cowl fasteners. I want to use Camloc fasteners rather than the Dzus fasteners that come with the kit. The Camloc parts are more user-friendly when it comes to unfastening and re-fastening of the cowling. For best results, getting the fasteners a little farther away from the edges of the fiberglass cowl is a good thing to do. That involves replacing the factory cowl fastener strips with wider parts that I ordered from Midwest Sky Sports. They make these wider strips and use them for the planes they build and they seem like a good idea to me.

The rivets holding the factory-strips needed to be drilled out. I did it. Now I don’t have that to contemplate anymore. I did a quick fit of the new cowling fastener strips. They look like they fit pretty well. That’s a relief after removing the factory parts.