Rudder Pedals – Final Fit

Trial fitting revealed that clearance between the arms on the pedal tubes and the hands of the travel-stops, bolted to each opposite arm, was nil. I could actually hear a squeak sound where there was contact, as I worked the pedals back and forth with my hands.

I pondered what to do about it, using my tried and true procrastination skills. As I have no proper equipment for clamping and bending anything heavier than light sheet metal – removing a bit of material from the the lower hand of each travel-stop came to my mind as the answer.

The pedal tubes were removed from the center-fuselage and the travel-stops unbolted from their respective arms. The Scotch-Brite wheel on my bench grinder did a fine job and I was easily able to remove about 1.5mm of material from the lower hands of the travel-stops to open up a satisfactory clearance.

The parts were reassembled and the pedal tubes reinstalled on the floor of the center fuselage. This time around, I installed the upper retainer brackets differently than I had for the trial fit. By now, I’ve noticed what several other builders and the factory are doing. For each bearing, there are a pair of top retainers. Rather than both retainers being together on the same side of the lower bracket, I’ve put one on either side, with space between. That seems to be the way it’s supposed to be. I like it.