With a now ample supply of 4,8mm rivets in both 15 and 10 mm lengths, finishing the lefthand flap could proceed. I did, however, have to make a decision about how to address hole misalignment involving the short ribs of the hing-rib subassemblies. The solution I chose was hole enlargement and larger 4mm rivets.
I’ve learned that perfect factory bends are required in order to get relaxed fit and freedom from structure twists and wags on the trailing edges of control surface skins. Knowing what to look for during inspection is essential. It had been months since I’d received the quick-build wing kit components and done my inspections. I was reasonably confident the skins were good, yet there was a huge sense of relief to see them actually fitting very nicely.
For the flaps and ailerons, it is common practice to initially rivet only the bottom surface of the skins to the ribs and brackets. The top surface and the row of rivets at the leading edge of the control surface remain free until they are fitted to and the trailing edges are perfectly aligned with the each other and the wing.