Tag Archives: heat

Under the Cowl – Work Goes On

With a bit of study and suitable periods of procrastination, I was able to rework the newer of the cabin heat shroud parts to fit the muffler. Knowledge and experience gleaned from my work with the heat valve duct was transferred to the outlet duct for the muffler shroud.

I got a start on the oil hoses and fittings. I’ve elected not to use any of the hose and a number of the fittings supplied with the FFW kit for the oil system. Rather than struggle with a vice to clamp fittings and attempting to push the hose onto the barbs – by hand – I picked up a Koul Tool. Not cheap, but it works ever so nicely – if, that is, your 90 and 45 degree fittings have a shoulder. Some of the FFW kit fittings don’t have a shoulder. I’ve replaced those with Aeroquip AQP AN8 fittings. I’ve also gone with matching high temp Aeroquip oil hose. All very nice stuff. Each hose I’m making has swivel fittings at both ends to make an entire system of modular components. Admittedly, I’ve deviated slightly from the plans and supplied parts here, but in a good way. I’m building as experimental in the USA, so I can tweak some things without a big hassle.

Now seemed like a good time to get the radiator and oil cooler secured to the lower cowl with the factory-supplied Sling 2-specific brackets. I’m using Camlocs instead of the kit-supplied Dzus fittings. They’re just better.

Cowl fitting continues, this time with a minimal cutout to clear the exhaust pipe. Eventually, I’ll be bonding reflective fiberglass heat shield to the inside of the cowling where needed.